| eMU-S - 12 Output PDU | Key
Features 20A Powercon Input 16A Input Fuse 12 Individually Fused IEC Outputs (6A) Sequential Power On Power Shedding LAN Control via LAN Enabled eMU-M 1U x 250mm Deep
click on image to enlarge it |
||
| Description | |||
| The eMU-S is a twelve output power distribution unit that can be remotely controlled and monitored from an eMU-M (LAN Enabled PDU). | |||
| Features | |||
| Inputs: | 20A 'Powercon' connector with front panel 16A fuse. | ||
| Outputs: | Twelve 6A individual fused IEC output. | ||
| Status LED: | Front panel LEDs show the status of
each output. ON – Output relay is on and the fuse is OK OFF – Output relay has been switched off FLASH – Output relay is on but fuse blown |
||
| Sequential Switch On: |
On power up the outputs can be programmed to switch on sequentially to avoid switch on current surges. | ||
| Power Shedding: | Outputs can be setup as non critical, so in the event of needing to reduce the power load, these outputs can be ‘shed’ by a single closing contact input. | ||
| Embedded Web Server: |
The status, control and setup can be accessed via standard web browsers (if it is connected to a LAN enabled eMU-M). | ||
| LAN Control: | A TCP socket protocol enables the eMU-M to be controlled by third user developed or third party software like Crestron or AMX (if it is connected to a LAN enabled eMU-M. | ||
| Email Alerts: | Fuse failure and ups on/off event notification via SMTP (if it is connected to a LAN enabled eMU-M. | ||
| Options: | Rear cable tiebar. | ||
| Alternative Products: | See the full range of power distribution units | ||
